Fujitsu Airstage J-II Series Design & Technical Manual page 661

z Dual remote control switch for Wired remote controller, Simple remote
„
controller (Set I)
When 2 wired remote controllers are connected to the remote control group, select the.
● Slave remote controller cannot be used for timer setting.
„
● Last command is priority.
„
[Master] [Slave]
SW2 OFF ON
of DIP Switch 1
Remote controller unit PCB
Setting by SW 2 of DIP Switch 1
z Dual remote control switch for Wired remote controller (Touch panel)
„
(Set J)
When 2 wired remote controllers are connected to the remote control group, select the [Master]
or [Slave] on the "RC Master / Slave Setting" screen.
● Slave remote controller cannot be used for timer setting.
„
● Last command is priority.
„
[Master] [Slave]
z Signal amplifier address (Set K)
„
[Master]
SW2 OFF
of DIP Switch 1
When only 1 remote controller will connect,
this SW 2 of DIP Switch 1 must be set OFF.
[Master]
Signal amplifier
(Max.8)
- (07 - 14) -
1
2
3