Fujitsu Airstage J-II Series Design & Technical Manual page 737

„ SWITCHING SELECTION OF FUNCTION SETTING MODE
„
(2) Press and hold the "MANUAL/AUTO"
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
● The position of the "MANUAL/AUTO" button varies depending on the model.
Refer to the operation manual for the button position on your unit.
● Indoor unit will display on "TIMER
continuously pressing the "MANUAL/AUTO" for 10 sec or more. In this case release the button or turn off the
power.
● An explanation of the displayed information is shown below.
„ SELECTION AND CONFIRMATION OF CUSTOM CODE
„
(4) Press the " SET TEMP.
TEMP. " buttons to select the custom
q
code that matches the setting with the
indoor unit. By selecting the appropriate
custom code, the communication between
the indoor unit and the wireless RC is
enabled.
CUSTOM CODE
( - - - )
The initial setting is " "
(3) Press and hold the "FAN" and the " SET
Pi Pi Pi
MANUAL
AUTO
"(ORANGE) and "FILTER
" or " SET (5) Press the "TIMER MODE" button to send
p
- (07 - 90) -
TEMP. " buttons. While holding these 2
p
buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
"(RED) light (1sec ON / 1sec OFF) by
the code to the indoor unit.
Correct code:
Wrong code:
No Response
Function setting
mode display
Pi Pi