System Configuration Options (Licensing) - Keysight N9923A FieldFox User Manual

System Configuration
Options (Licensing)
You can view and install options on your FieldFox. See all available options on page
8.
How to view the Installed Options
 Press System 7
 Then
 Then
 Then
The currently installed options are listed.
How to Install Options
A .lic file must already be on a USB Flash Drive. To learn how to obtain a .lic file,
visit:
Insert the USB Flash Drive in the FieldFox.
 Press System 7
 Then
 Then
 Then
 Press and hold the power button to shutdown, then restart the FieldFox.
How to Delete ALL Options
Deleting individual options is NOT supported.
 Press System 7
 Then
 Then
 Then
 Then
After a warning message, all options on the FieldFox are deleted.
NOTE
Delete All CFG Options
138
OFF – Source power is kept ON at all times, including during trigger Hold mode
o
and between single sweep acquisitions. The RF source stays at the stop
frequency until another sweep begins. This provides a constant, uninterrupted
RF output from the current source port: PORT 1 with forward measurements or
PORT 2 with reverse measurements (Opt 122). This behavior also provides the
highest trace stability sweep-to-sweep which may only be evident while using
either single sweep or Run/Hold. With Battery Save OFF, the use of a full
battery charge is reduced by approximately 45 minutes.
System Configuration
Options(Licensing)
Show Options
http://www.keysight.com/find/softwarelicense
System Configuration
Options
The FieldFox reads, validates, then installs the options.
Install Options
System Configuration
Options
Advanced
Delete All Options
is to be used by Service Personnel ONLY.
FieldFox User's Guide