Setting The Operational Mode - EBARA ESA70W Instruction Manual

6.3 Setting the operational mode

This section describes how to set the operational mode. In the normal state, the
LCD controller displays pump status. To display the operational mode setting
screen, press the key "PRG." for three seconds or longer. Pressing the key for one
second or longer again returns to the pump status display screen. Table 6.3 below
shows indications and the details of the operational mode setting.
Item
Pump operation setting
mode
DIP switch setting
Pump N WARNING setting
2
WARNING value for the
backpressure setting
(option)
Keys work as below for the setting screen.
START :
STOP :
RESET :
BZ.OFF :
▲ :
▼ :
ENTER :
See Fig. 6.3 for how to set the operational modes.
Table 6.3 Operational mode setting screen
Indication
SET
CONTROL MODE?
SET
DIP SW?
SET POINT
PUMP N2 WARNING?
SET ALARM SP
BACK PRES. ?
Valid
Stops the pump.
Resets WARNING and /or ALARM.
Switches the DIP switch No.
Sets the DIP switch to ON. Switches the display of the operational
mode setting screen.
Sets the DIP switch to OFF. Switches the display of the operational
mode setting screen.
Determines the selected setting.
(29)
Description
Switches the control modes:
local /remote/communication.
To set DIP switchs (see 6.4).
Sets the WARNING value for
N flow.
2
Sets the WARNING value for
the backpressure.
EBARA
Corporation