Machine Configuration - Xerox WorkCentre 5230A System Administration Manual

4.
Configure the fax server, referring to the fax management software
manufacturer's documentation, so that it is able to monitor the fax repository for
incoming documents.
NOTE: Follow the fax server software manufacturer's instructions for any other
settings required to use the Fax Server service.

Machine Configuration

1.
Set TCP/IP and HTTP for the machine. This is required to access CentreWare
Internet Services, which can be used to configure Server Fax settings from a
networked computer. For details on how to set TCP/IP and HTTP, refer to
CentreWare Internet Services Installation on page 150
2.
Enable the port to be used for the Server Fax service. The transfer protocols
available for the Server Fax service are FTP, SMB, and SMTP. For details on how
to enable a port, refer to
NOTE: To verify that TCP/IP and HTTP are correctly configured and the port is
enabled, you can print a Configuration Report. For information on the Configuration
Report, refer to
3.
Follow the steps below to enable the Server Fax service, to set the fax repository
(the directory on the Server Fax server to store transferred images), and then to
set the protocol.
1) Start a web browser on a computer.
2) In the URL field, enter "http://" followed by the Internet address of the machine.
Then press the <Enter> key on the keyboard.
NOTE: If you use the IP address to specify the machine, use one of the following
formats depending on your machine configuration. The IPv6 format is supported on
Windows Vista only. An IPv6 address needs to be enclosed in square brackets.
NOTE: If you have changed the port number from the default port number "80",
append the number to the Internet address as follows. In the following examples, the
port number is 8080.
The following describes how to enable the Server Fax service. If the Fax service is not
installed on the machine, skip steps 3) to 7) and proceed to step 8).
3) In CentreWare Internet Services, click the [Properties] tab.
4) Expand the [Services] folder, and then expand the [Fax] folder.
5) Click [Fax Settings], and then under [Fax Service], select [Scan to Fax Server].
6) Click the [Apply] button.
7) On the right frame of the screen, click [Reboot Machine] to reflect the setting.
The following describes how to configure the repository settings. The repository
settings can only be configured using CentreWare Internet Services.
8) In CentreWare Internet Services, click the [Properties] tab.
9) Expand the [Services] folder, and then expand the [Fax] folder.
10)Click [Defaults].
Port Settings on page 90
Machine Status on page 49
(For IPv4) http://xxx.xxx.xxx.xxx
(For IPv6) http://[xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx]
(For IPv4) http://xxx.xxx.xxx.xxx:8080
(For IPv6) http://[xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx]:8080
Server Fax Installation
.
.
.
303