Machine Clock/Timers - Xerox WorkCentre 5230A System Administration Manual

6 Setups

Machine Clock/Timers

This feature allows you to set the correct date, time, and other related values.
1.
Select [Machine Clock/Timers]
in the [Features] menu.
2.
Change the required settings.
Use the side tabs to switch
between screens.
3.
Select [Close].
Date
Specifies the current date. Select from three date formats: Y/M/D, M/D/Y, and D/M/Y.
The date set here is printed on lists and reports.
Time
Specifies the current time. Select a 12- or 24-hour display format. If you select [12 Hour
Clock], the buttons for specifying AM or PM are displayed. The time set here is printed
on lists and reports.
Time Zone
Specifies the time zone relative to Greenwich Mean Time (GMT).
Daylight Savings
Specifies whether to automatically adjust the machine clock for Daylight Savings.
• WorkCentre 5225A/5230A:
Select [Adjust by Day, Month & Time] or [Adjust by Month, Week, Day of Week &
Time], and then specify the start and end dates of the Daylight Savings time to
automatically adjust the current time when the Daylight Savings time starts and
ends.
• WorkCentre 5222/5225/5230:
Select [Adjust On] and then specify the start and end dates of the Daylight Savings
time to automatically adjust the current time when the Daylight Savings time starts
and ends.
NTP Time Synchronization
Specifies the parameters used to synchronize the time of the machine with that of the
specified time server using the Network Time Protocol (NTP).
NOTE: If the time server connection fails, the machine maintains its own time without
synchronization.
• Connection to Time Server
Specifies whether to enable the connection to a time server.
• Connection Interval
Specifies the time span between connections to the specified server, in the range
from 1 to 500 hours.
• Time Server Address
Specifies the IP address of the time server using the numeric keypad on the control
panel.
66