Xerox WorkCentre 5230A System Administration Manual page 114

6 Setups
2 Pages Up On Receipt
Specifies whether to print consecutively received two documents onto one page. It is
effective in saving paper. If the number of received pages is odd, a blank page will be
added at the end. If the sizes of received pages are different, the larger size will be
used.
NOTE: If the same size paper as the received document size is available, that paper
will be printed even when you set this feature to [Yes].
2 Sided Printing
Specifies whether to print received documents or private mailbox documents onto both
sides of a sheet. This is effective in saving paper.
NOTE: Some data may not allow you to use this feature even when you set it to [On].
Edge Erase - Top & Bottom Edges
Specifies the margin on the top and bottom of the received document by cutting off the
original image. You can set the margins within the range of 0-20 mm (0-0.8 inches)
using the scroll buttons or the numeric keypad on the control panel.
Edge Erase - Left & Right Edges
Specifies the margin on the left and right of the received document by cutting off the
original image. You can set the margins within the range of 0-20 mm (0-0.8 inches)
using the scroll buttons or the numeric keypad on the control panel.
Reduce 8.5×11" SEF Original to A4 SEF
Specifies whether an 8.5 × 11.0 inches (216 × 279 mm) size document is to be reduced
to the A4 size when [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto
%].
Pseudo-Photo Gradation Mode
Specifies whether to perform gradation level correction for documents containing
photographs. Select from [Error Diffusion] and [Dither].
Mailbox Selector Setup
Specifies whether to sort the received documents to the mailboxes by the incoming line
when more than one line is in use.
NOTE: When setting the mailbox selector feature, select a mailbox that has already
been registered. If an unregistered mailbox is selected, the received document is
automatically printed instead of stored in a mailbox.
Memory Full Procedure
Specifies the default process to execute if the hard disk becomes full while reading
documents. A message asking how to process the data read up to that point is
displayed. You can predefine a processing method to be performed after the message
has been displayed for a specified period. If you select [Delete Job], the data will be
discarded. If you select [Run Job], the data read up to that point will be processed.
Maximum Stored Pages
Specifies the maximum number of pages that can be stored in memory when you copy
documents. Select a number in the range from 1 to 999.
114