Xerox WorkCentre 5230A System Administration Manual page 75

Initialize Hard Disk
This feature allows you to initialize the hard disk on the machine. After selecting
[Initialize Hard Disk], select a partition, and then select [Start]. Then select [Yes] to
execute initialization. After the initialization is completed, select [Confirm].
NOTE: This process may take a while depending on the machine configuration.
Delete All Data
Allows you to delete all document data on the machine. Select [Delete All Data], and
then select [Start]. Then select [Yes] to execute deletion. After the deletion finishes, you
need to switch the machine off and then on.
NOTE: This process may take a few hours depending on the machine configuration.
Software Options
Specifies software options. For information on setting procedures and software codes,
refer to the instructions for the required software option package. Enter passwords for
the software options using the keyboard screen and select [Reboot].
Document Feeder Scanning Position
Allows you to adjust the scanning position for the document feeder. To reset the
scanning position to the factory-default position, use the [Factory Settings] button.
Finisher Adjustment
Allows you to configure the punch and booklet functions of the Office Finisher LX.
• Hole Punch Tool
Displays the available hole punch tools. Select the hole punch tool installed on the
Finisher.
• Adjust Punch Position/Booklet Fold Position
– Punch Position, smaller than B4 - Allows you to adjust the punch position for
paper smaller than the B4 size.
– Punch Position, B4 or larger - Allows you to adjust the punch position for B4 or
larger paper.
The following explains how to adjust the punch position.
1.
Select [Punch Position, smaller than B4] or [Punch Position, B4 or larger], and
then select [Change Settings].
2.
On the screen displayed, select [Sample Printout], and then select the tray to
output a sample printout for. Press the <Start> button.
3.
Enter the value of the current punch position into [Value A Before Adjustment].
4.
Enter the desired punch position into [Desired Value A].
5.
Select [Adjust] to apply the setting.
6.
Select [Sample Printout] and then select the tray again, to output a sample
printout. Check with the sample printout that the punch position has been
adjusted.
– Booklet fold Position, smaller than B4 - Allows you to adjust the fold and staple
positions for paper smaller than the B4 size.
– Booklet Fold Position, B4 or larger - Allows you to adjust the fold and staple
positions for B4 or larger paper.
System Settings
75