Xerox WorkCentre 5230A System Administration Manual page 256

8 Printer Environment Settings
Specifying the print mode
The following print mode parameters can be specified.
Parameter
GC/gc
GB/gb
NOTE: If several parameters are specified in the first lpr command, data may not print.
NOTE: The system default is used if no parameter is specified.
Specifying stapling
The following parameters can be specified for stapling.
STAPLETL
STAPLETD
STAPLETR
STAPLELD
STAPLERD
STAPLEBL
STAPLEBD
STAPLEBR
NOTE: If several parameters are specified in the first lpr command, data may not print.
NOTE: For some print languages, the stapling parameter may be invalid.
Printing
To specify the output format for printing, enter the following command:
Enter a "," (comma) after -C followed by the parameters which specify the output
format. To specify multiple parameters, separate them with ",".
For example, to print a file named "file1", two-sided on A4 (210 × 297 mm/8.3 × 11.7
inches) on printer fxPS, enter the following command:
NOTE: If a parameter string of the -C option exceeds 64 characters, the operation
may not function correctly.
256
Selects quality priority.
Selects speed priority.
Parameter
Places one staple in the upper left corner of the prints.
Places two staples at the top of the prints.
Places one staple in the upper right corner of the prints.
Places two staples on the left side of the prints.
Places two staples on the right side of the prints.
Places one staple in the lower left corner of the prints.
Places two staples at the bottom of the prints.
Places one staple in the lower right corner of the prints.
-C,[parameter],[parameter]
%lpr -PfxPS -C,DUP,A4 file1
Description
Description