Xerox WorkCentre 5230A System Administration Manual page 210

7 CentreWare Internet Services
Services
210
Feature
Network
Scanning
(continued)
Setting items
File Repository Setup (Continued)
• Share – Enter the shared name. This appears only
when [SMB] is selected in [Protocol].
• Scriptpath and filename (from HTTP root) - Specify
the script path and file name. This appears only
when [HTTP] or [HTTPS] is selected in [Protocol].
• Document Path – Specify the path to the file
repository using up to 128 characters.
• Server Name - Specify the server name. This
appears only when [NetWare] is selected.
• Server Volume - Specify the server volume. This
appears only when [NetWare] is selected.
• NDS Context - Specify the NDS context. This
appears only when [NetWare] is selected.
• NDS Tree - Specify the NDS tree. This appears only
when [NetWare] is selected.
• Login Credentials to Access the Destination – Select
[System] to specify the login name and password on
this page. Select [Prompt at User Interface] to
specify the user ID and password on the machine's
control panel when requesting a job. Select [None]
to disable authentication. [None] appears only when
[HTTP] or [HTTPS] is selected.
• Login Name – Specify the login name to use.
• Password – Specify the password for the login
name.
• Retype Password – Re-enter the password for
verification.
Alternate File Destinations – Allows you to manage
alternate file destinations for scanning. Select [Add],
[Edit], or [Delete] to manage the destination list.
Validation Servers
Allows you to add, edit, or delete meta data validation
servers.
Add – Displays the [Add Validation Server] page, which
allows you to configure the following settings.
Server Information:
• Protocol – Select the protocol of the server to be
added.
• Host Name/IP Address & Port – Enter the host
name/IP address and port number of the server.
• Path – Specify the path of the server.
• Response Timeout – Specify the time in seconds
after which the server will time out.
Edit – Displays the page which allows you to edit the
above settings for the selected server.
Delete – Deletes the selected server.
Scan Template Management
Setup – Displays the steps required to set up a job
template and status of each step (whether required or
not).
Template Management Service – Select whether or not
to enable the template management service.
Default Template
Allows you to define the default job template. For more
information on the options available, refer to the
Templates on page 162
.
Job