Centreware Internet Services Environments; Centreware Internet Services Installation; Installation Procedure; Network Communication Setup - Xerox WorkCentre 5230A System Administration Manual

7 CentreWare Internet Services

CentreWare Internet Services Environments

CentreWare Internet Services uses the embedded HTTP Server that resides in the
machine. This allows communication with the machine through a web browser with
access to the Internet or an intranet. By entering the IP Address of the machine as the
URL (Universal Resource Locator) in the browser, direct access to the machine
becomes available.
CentreWare Internet Services allows you to make not only the same basic settings as
from the control panel, but also more specialized settings for the machine.
User ID and Passcode
Many of the features available within Internet Services will require the System
Administrator login ID and passcode. The default user ID is "11111" and the default
passcode is "x-admin". This ID and passcode can be changed by the System
Administrator. A user will only be prompted for the System Administrator login ID and
passcode once in a single browser session.
System Configuration
To use CentreWare Internet Services, you need to enable TCP/IP on the machine.

CentreWare Internet Services Installation

This section describes the settings required to use CentreWare Internet Services.

Installation Procedure

There are two stages required to enable CentreWare Internet Services.

Network Communication Setup

This requires the machine to be set up for CentreWare Internet Services.
Test Access
To make sure that CentreWare Internet Services has been set up correctly, you should
access CentreWare Internet Services.
Network Communication Setup
Initially, boot the CentreWare Internet Services port.
1.
Connect the machine to the network.
2.
Press the <Log In/Out> button on the control panel, and then type the System
Administrator login ID to enter the System Administration mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4.
Select [System Settings] in the menu at the left side of the screen.
5.
Select [Connectivity & Network Setup] in the [Group] menu.
150