Configuration On The Machine; Connect To Centreware Internet Services From A Computer - Xerox 4112 System Administration Manual

Using CentreWare Internet Services

Configuration on the machine

This section describes the configuration procedure for using CentreWare Internet Services on
the machine.
First enable the Internet service port, then set the IP address.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
on page 1-10.)
2. Enable either the LPD port or the Port 9100 port as appropriate. In this example, the LPD
port is enabled.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select Internet Services (HTTP) and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enabled and then select Save.
g. Select Close repeatedly until the Connectivity & Network Setup screen is displayed
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
5. After the machine is restarted, print out the Printer Settings List to confirm that the
Internet service port is enabled.

Connect to CentreWare Internet Services from a computer

1. Start a web browser.
2. Type the IP address or the Internet address for the machine in the address bar on the
browser, and press the Enter key.
• Example of the IP address (when the machine IP address is 192.168.1.1):
• http://192.168.1.1/
• Example of the Internet URL (when the machine Internet address is in the form
xxx.yyy.zz.vvv):
3-2 System Administration Guide
Xerox 4112/4127 Copier/Printer