Configuration On The Machine (Lpd) - Xerox 4112 System Administration Manual

2. C on f ig u r at i on
2- 2

Configuration on the machine (LPD)

This section describes the configuration procedure to use TCP/IP
(LPD/Port 9100) protocol on the machine. First enable the LPD
Port or Port 9100 port, then assign the IP address.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Enter the System Administrator Mode (Chapter 1 Entering the
1.
System Administrator Mode on page 1-15.)
Enable either the LPD port or the Port 9100 port as
2.
appropriate. In this example, the LPD port is enabled.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select LPD and then select Change Settings.
e. Select LPD - Port Status and select Change Settings.
f. Select Enabled and then select Save.
g. Select Close repeatedly until the Connectivity & Network
Setup screen is displayed
If necessary, set the IP Address (Chapter 1 Setting the IP
3.
address. on page 1-17).
4. Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
5. After the machine is restarted, print out the Printer Settings
List to confirm that the LPD port is enabled.
Configure the LPD as necessary. Refer to "LPD" on page 3-13 for
the LPD configuration. Also if using Port 9100, configure as
necessary. Refer to "Port 9100" on page 3-18 for the Port 9100
configuration.
Xe r o x 4112 /4 1 27 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e