Agilent Technologies 8719ET Service Manual page 62

System Verification and Performance Tests
Performance Tests
8722ET/ES Models
1. Press
Stop 20
2. Press
Sweep Setup
3. Refer to Table 2-10
for the particular analyzer under test. After you enter the value, press
4. Wait for analyzer to complete one full sweep.
DATA → MEMORY
5. Press
Display
∆ MODE MENU
6. Press
Marker
.
0 x1
Recording P Data
1
7. Press
Sweep Setup
8. Enter the power value that is listed in the P
analyzer under test. After you enter the value, press
9. Wait for analyzer to complete one full sweep.
10.Press
Marker Search
11.Read the marker value from the analyzer display and add 5 dB. Record the calculated
value in the 8722ET/ES (0.05 − 20 GHz) "P
performance test record.
SEARCH: MIN
12.Press
13.Read the marker value from the analyzer display and add 5 dB. Record the calculated
value in the 8722ET/ES (0.05 − 20 GHz) "P
performance test record.
Recording P Data for the 20 GHz to 40 GHz Band
1
14.To record data for P
15.Press
Stop 40
16.Repeat steps 2 through 13 of the section, except record the values in the 8722ET/ES
(20 − 40 GHz) "P
1
test record.
2-40
.
G/n
.
POWER
and set the analyzer to the power value that is listed in the P
DATA/MEM
FIXED MKR POSITION
.
POWER
SEARCH: MAX
.
data in the 20 GHz to 40 GHz band, press
1
.
G/n
Max." and "P Min." columns of the "Source Linearity" performance
1
.
row of Table 2-10
1
.
x1
.
Max." column of the "Source Linearity"
1
Min." column of the "Source Linearity"
1
8719ET/20ET/22ET
8719ES/20ES/22ES
RF Network Analyzers
Ref
.
x1
FIXED MKR VALUE
for the particular
Start 20 G/n
Service Guide
row
.