Table of Contents
Advertisement
68/172
Assembly
Please note:
• Minimize lateral offset
during this step as much as
possible. Fine adjustments
will be made later.
• Due to thermal expansion
during operation, the
modules should always
have a min. spacing of
0.5 mm from each other.
This spacing should never
be less than 0.5 mm.
Required tool
• 0.5 mm plastic feeler gauge
1.
Use your finger and a
straight edge to check
that the V-rails have the
lowest possible lateral
offset at the joints.
2.
To align the section
modules, loosen the
bottom fastening
screws in both module
holders and move them
accordingly.
3.
Make sure all modules
have a min. spacing of
0.5 mm from each other.
4.
Tighten the fastening
screws.
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
7.5.6
Aligning section modules (rough adjustment)
!
Fig. 45:
Adjusting lateral offset of section modules (rough adjustment)
!
3
X = 0,5 mm
2
4x
4
SW6
4x
SW6
M
=18 Nm
D
1
557 186-45
Advertisement
Table of Contents
