Table of Contents
Advertisement
Please note:
• Keep the protection plates
in a safe place. Always
attach the protection
plates during removal.
• Set the protection plate
on the magnet kit with the
plastic cover on.
• The discharger brush
guards should be in the
slot below the V-rail.
1.
Remove all workpiece
pallets near the remover
tool.
2.
Open the locking hook (B)
on the remover tool (A).
3.
Attach the remover tool
(shorter arm on the left).
4.
Secure the remover tool
with the locking hook (B)
and the detent screw (C).
Damage due to negligent workpiece pallet mounting
If the workpiece pallet is set on the section or curve module too hard, it can
damage the WT itself or the section/curve module cover.
Only use the included remover tool.
„
Always hold the remover tool with both hands.
„
Be prepared for the high pull strength.
„
Set the WT on the section/curve module carefully and as gently as possible.
„
2
A
Fig. 54:
Mounting workpiece pallet (1)
NOTICE
!
m i
n .
!
3
B
3 842 559 521/2018-07, MIT: ActiveMover, Bosch Rexroth AG
Assembly
77/172
4 0
0 m
m
m i
n .
4 0
0 m
m
!
4
2x
C
557 186-54
Advertisement
Table of Contents
