52/172
Assembly
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
Overall systems with a length < 10 m
Begin assembly with a system section with a section module
of a system section with a curve module.
These system sections with section modules will be referred to as reference
system sections.
53
Fig. 29:
Order of assembly for overall system with a length < 10 m
Mount additional, adjacent system sections.
Make sure all other mounted system sections are plumb, level and square with
the reference system section.
Final inspections and adjustments
Make sure the module spacing is 0.5 mm.
Make sure the laminations of the linear motors between the section/curve
modules are flush.
Assemble the profile connectors on the back side of the joint between the
section/curve modules.
Adjust the transition of the V-rail with the profile connector.
Check the transition between the section/curve modules with a workpiece pallet.
4
3
1
to the left or right
2
557 186-29