30 � en | Troubleshooting
8 �
Troubleshooting
This section includes trouble conditions and the potential causes.
8.1
Motion detector does not appear to respond to motion
Potential causes
– �
Insufficient power
– �
Loose wires in the terminals
– �
Cabling or wiring error
– �
Defective unit
– �
Walk test LED is disabled
Notice!
Some regulations require that you disable the LED after the walk test.
8.2 �
Motion detector is in continuous alarm
Potential causes
– �
Mounting location does not meet the recommendations listed in this document
– �
Insufficient power
– �
Input loop continuity broken
– �
Incorrect alarm loop resistance configuration
– �
Defective unit
– �
Masking attempt detected
8.3 �
Motion detector does not appear to detect motion in the space
directly under it
Potential causes
– �
The look-down zone is disabled
8.4 �
Motion detector does not appear to detect motion near the
edge of the coverage area
Potential causes
– �
Microwave range too short
– �
Mounting height does not meet the recommendation listed in this document
– �
Level alignment does not meet the requirement noted in this document
– �
C
8.5 �
Motion detector does not appear to detect motion in the
farther section of the coverage area
Potential causes
– �
Microwave range is too short
– �
C
8.6 �
Motion detector LED flashes continuously
Potential causes
– �
Warm-up mode requires a certain amount of time with no motion in the area to settle the
PIR and microwave circuit
– �
Defective unit
2017.09 | 03 | F.01U.309.350
2
DT sensitivity too low*
2
DT sensitivity too low
Reference Guide �
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Commercial Series TriTech+ Motion Detector with
Bosch Security Systems, Inc
Anti-mask