Table of Contents
Advertisement
Please note:
• Minimize height offset
during this step as much as
possible. Fine adjustments
will be made later.
• Due to thermal expansion
during operation, the
modules should always
have a min. spacing of
0.5 mm from each other.
This spacing should never
be less than 0.5 mm.
Required tool
• 0.5 mm plastic feeler gauge
1.
Use your finger and a
straight edge to check
that the V-rails have the
lowest possible height
offset at the joints.
2.
To align the section
modules, loosen the top
fastening screws in both
module holders.
3.
Adjust the height with
the adjusting screw.
4.
Make sure all modules
have a min. spacing of
0.5 mm from each other.
5.
Tighten the fastening
screws.
Fig. 46:
Adjusting height offset of section modules (rough adjustment)
3
SW6
SW13
M
=21 Nm
D
!
4
X = 0,5 mm
3 842 559 521/2018-07, MIT: ActiveMover, Bosch Rexroth AG
Assembly
69/172
1
2
4x
SW5
5
4x
SW5
M
=7 Nm
D
557 186-46
Advertisement
Table of Contents
