Table of Contents
Advertisement
158/172 Maintenance and servicing
5.
Start AMpro and
navigate to Diagnostic
Encoders
Encoder
„
„
Strip Setup.
6.
Click on the encoder on
which the fixing element
is centered
(odd number).
If the display is green
(±4 µm), the measuring
system is properly
calibrated.
If the display is red,
readjustment is needed.
7.
Slightly loosen the
measuring system
screws.
8.
Carefully adjust the value
with 2 long hex socket
wrenches on the inner
adjusting screws until
the display turns green.
Please note:
• When making
adjustments, it is
recommended to always
loosen one inner adjusting
screw and then slightly
tighten the other.
• Do not overtighten the
adjusting screws.
This could move the
calibration set.
9.
Tighten the measuring
system screws.
10.
Check the display again.
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
8
SW
Fig. 118:
Checking calibration set position (2)
6
7
SW
9
SW
M
= Nm
D
8
SW
557 186-118
Advertisement
Table of Contents
