Table of Contents
Advertisement
8.2.1
Life stages of the machine
According to EN 12100 Section 5.4 a /b (No. 1–27), Section 5.4 a
1
Transport, assembly and installation
2
Start-up
3
Use
4
Disassembly, shutdown and disposal
5
Setup
6
Inspection
7
Teaching/programming
8
Changeover
9
Warm-up
10
All operating modes
11
Loading the machine
12
Unloading the machine
13
Shutting the machine down
14
Shutting the machine down in an emergency
Restoring operation after backup or blockage
15
16
Restarting after unscheduled shutdown
17
Troubleshooting and fault clearance (intervention by operating personnel)
18
Cleaning and keeping clean
19
Preventive maintenance
20
Corrective maintenance
Operating states of the machine (Section 5.4 b)
21
Normal operation
22
Change in a property or dimension of the material or workpiece being processed
23
Failure of one or more components or supply units
24
External disturbances (e.g. impact, vibration, electromagnetic interference)
25
Design faults or defects (e.g. software errors)
26
Power supply fault
27
Environmental conditions (e.g. damaged floors)
8.3 Returning to service
Follow the steps for initial start-up.
8.4 AMpro configuration software
The AMpro configuration software is required for start-up, configuration,
parameterization, calibration and troubleshooting.
For the description of the software, see the separate AMpro manual.
You can download the manual online at:
www.boschrexroth.com/mediadirectory
3 842 559 521/2018-07, MIT: ActiveMover, Bosch Rexroth AG
Start-up 105/172
Advertisement
Table of Contents
