Table of Contents
Advertisement
82/172
Assembly
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
7.6 Connecting product to power
Death or serious injury from improper connection/wiring of multiple safety
circuits!
Systems with multiple safety circuits in which the section modules have been
improperly connected to power pose a risk of death or serious injury.
Perform a risk assessment per DIN EN ISO 12100 before starting up a conveyor
„
system for the first time or returning one to service.
The section/curve modules of different safety circuits should not be connected to
„
the same power supply (PCBs can be connected to the same logic power supply).
Death or serious injury from electric shock!
In areas that are marked with this hazard symbol, there is a risk of death or
serious injury and burns from electric shock.
Observe all NFPA 79 (NA) and EN 60204-1 (EU) requirements for safely working
„
on electrical systems, as well as all national and international regulations
applicable at the place of use.
Wear personal protective equipment that is appropriate for the place of use and
„
use suitable tools.
Death or serious injury from residual energy!
After the power supply to the section and curve module motors has been
shut off, there is still a risk of death or serious injury and burns from energy
stored in the capacitors.
After the power supply has been shut off, access should remain blocked by an
„
interlocking guard with locking mechanism to allow the energy in the capacitors
to discharge.
High electrical voltage
Risk of death or serious injury from electric shock.
Make sure the relevant system component is dead before assembly.
„
Secure the system against unintentional restarting.
„
Uninterruptible power supply!
Voltage may be present even with the main switch off!
Coming into contact with electrical components can result in injury and
burns from electric shock.
DANGER
WARNING
CAUTION
Advertisement
Table of Contents
