Bosch Rexroth ActiveMover Assembly Instructions Manual page 4

4/172
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
7.1 Unpacking
7.2 Installation requirements
7.2.1 Installation position
7.3 Required tools
7.3.1 Mechanical
7.3.2 Electrical
7.4 Symbols used
7.5 Assembling the product
7.5.1 During assembly
7.5.2 Setting up and aligning a base frame
7.5.3 Mounting section module on a base frame
7.5.4 Mounting curve module on a base frame
7.5.5 Adding and connecting system sections
7.5.6 Aligning section modules (rough adjustment)
7.5.7 Installing profile connectors
7.5.8 Aligning the V-rail (fine adjustment)
7.5.9 Mounting and aligning guide rails
7.5.10 Mounting/removing workpiece pallets
7.5.11 Mounting, adjusting and connecting ID system IR reading head
7.5.12 Mounting power supply
7.6 Connecting product to power
7.6.1 Installing EMC cable glands and cable guard pipes
7.6.2 Inserting connecting cables
7.6.3 Inserting power supply line in section/curve module
7.6.4 Connecting ground and power cables (28 V)
(from left section/curve module)
7.6.5 Connecting ground and power cables (28V)
(from right section/curve module)
7.6.6 Connecting network and control voltage cables (24 V)
(from left section/curve module)
7.6.7 Connecting network and control voltage cables (24 V)
(from right section/curve module)
7.6.8 Connecting the network connections and power supplies
in the control cabinet
7.6.9 ID system IR reading head (optional)
7.6.10 Network
7.6.11 Connecting power supply in the section module
7.6.12 Connecting power supply in the curve module
7.6.13 Connecting power supply in the control cabinet
7.6.14 Ethernet POWERLINK
7.6.15 Ethernet port (Windows PC)
7.6.16 PLC
7.6.17 Emergency stop safety circuit
7.6.18 Line voltage
8 Start-up
8.1 Initial start-up
8.2 Residual risks
8.2.1 Life stages of the machine
8.3 Returning to service
49
49
49
49
49
49
50
51
51
53
55
62
64
68
70
72
75
76
79
81
82
84
85
86
87
88
89
90
90
91
92
94
95
96
97
98
99
100
101
102
102
104
105
105