Table of Contents
Advertisement
64/172
Assembly
Please note:
Before adding and connect-
ing the system sections,
check that they are all
aligned with and the same
height as the reference
system section.
A:
System section with
section module
B:
System section with
curve module
C:
Holding-down clamp
D:
Top lock nut
E:
Bottom lock nut
F:
Leveling foot
1.
Check the alignment of
the system section with
section module (see
Fig. 38 on page 61).
2.
Check the alignment of
the system section with
curve module (see
Fig. 40 on page 63).
3.
If necessary, adjust
the height to match
the reference system
section:
Loosen the top lock
nut (D) and screw the
leveling foot (F) in or out
accordingly. Tighten the
top lock nut.
Bosch Rexroth AG, MIT: ActiveMover, 3 842 559 521/2018-07
7.5.5
Adding and connecting system sections
2
= 0,02 mm/m
B
3
(4x)
Fig. 41:
Checking system section alignment
A
1
= 0,02 mm/m
D
C
E
F
3
(4x)
SW36
SW24
557 186-41
Advertisement
Table of Contents
