Oam Remote Loopback - ZyXEL Communications XGS4600 Series User Manual

Table 190 Advanced Application > OAM > OAM Configuration (continued)
LABEL
Port
*
Active
Mode
Remote Loopback
Supported
Remote Loopback
Ignore-Rx
Apply
Cancel

43.4 OAM Remote Loopback

Use this screen to perform a remote loopback test. In the OAM Status screen click Remote Loopback to
display the screen as shown.
Figure 336 Advanced Application > OAM > OAM Remote Loopback (Standalone Mode)
Chapter 43 OAM
DESCRIPTION
This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last
two ports of your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable Ethernet OAM on this port.
Clear this check box to disable Ethernet OAM on the port.
Specify the OAM mode on the port.
Select Active to allow the port to issue and respond to Ethernet OAM commands.
Select Passive to allow the port to respond to Ethernet OAM commands.
Select this check box to enable the remote loopback feature on the port. Otherwise, clear
the check box to disable it.
Select this check box to set the Switch to process loopback commands received on the
port. Otherwise, clear the check box to have the Switch ignore loopback commands
received on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS4600 Series User's Guide
420