Table of Contents
Advertisement
39.4 OAM Remote Loopback
Use this screen to perform a remote loopback test. In the OAM Status screen click Remote Loopback to
display the screen as shown.
Figure 266 Advanced Application > OAM > OAM Remote Loopback
The following table describes the fields in the above screen.
Table 181 Advanced Application > OAM > OAM Remote Loopback
LABEL
Remote Loopback Test
Port
Number of Packet
Packet Size
Test
Remote Loopback Mode
Port
Start
Stop
Chapter 39 OAM
DESCRIPTION
Enter the number of the port from which the Switch performs a remote-loopback test.
Define the allowable packet number of the loopback test frames.
Define the allowable packet size of the loopback test frames.
Click Test to begin the test.
Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopback test.
Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.
GS2220 Series User's Guide
353
Advertisement
Table of Contents
Troubleshooting
