Table of Contents
Advertisement
Chapter 8: Configuring the Emulator
Modifying the Interactive Measurement Specification Configuration Items
Modifying the Interactive Measurement
Specification Configuration Items
In order to modify the interactive measurement configuration items, you must first
start the configuration interface. In the top-level configuration interface dialog box,
choose "Interactive Measurement Specification" under "Analyzer Configuration
Sections".
This section shows you how to:
•
•
•
•
344
Select whether or not the card cage rear panel BNC is connected to the Trig1
or Trig2 or both signals of the emulation-bus analyzer.
Select whether or not the coordinated measurement bus connection on the card
cage rear panel is connected to the Trig1 or Trig2 or both signals of the
emulation-bus analyzer.
Select whether or not the emulator will allow a signal on Trig2 to initiate an
emulation break.
Select whether or not the emulation-bus analyzer will ignore the Trig2 line of
the coordinated measurement bus.
Advertisement
Table of Contents
