Table of Contents
Advertisement
To break emulator execution on signal from CMB
• Choose Modify→Emulator Config ...
1
In the top-level emulator configuration dialog box, click on Interactive
Measurement Specification under Analyzer Configuration Sections.
2
Select "drive" for the "CMBT on Trig1" item.
• Using the command line, enter modify configuration.
1
Answer "yes" to the "Modify interactive measurement specification?" question.
2
Answer "drive" to the "Should CMBT drive or receive Trig1?" question.
The trig1 signal is always supplied to the emulator. By entering the command,
trace break_on_trigger emulation will break to the monitor when the CMB signal
occurs.
You could also break emulator execution on a trigger signal from the CMB over the
trig2 internal line by specifying that the CMB should drive trig2 and that the
emulator break should receive trig2.
Chapter 6: Making Coordinated Measurements
Using Trigger Signals
275
Advertisement
Table of Contents
