HP MC68040 User Manual page 737

Installing Sun SPARCsystem Software
This section shows you how to install the Graphical User Interface on Sun
SPARCsystem workstations. Installation involves installing the interface and the
64700 Operating Environment. These instructions also tell you how to prevent
installation of the Graphical User Interface if you want to use only the Softkey
Interface.
This section shows you how to:
1 Install the software from the media.
2 Start the X server and OpenWindows.
3 Set the necessary environment variables.
4 Verify the software installation.
5 Map your function keys.
Step 1. Install the software from the media
The tape that contains the Graphical User Interface software may contain several
products. Usually, you will want to install all of the products on the tape.
However, to save disk space, or for other reasons, you can choose to install selected
filesets.
If you plan to use the Softkey Interface instead of the Graphical User Interface, you
can save about 3.5 megabytes of disk space by not installing the filesets suffixed
"XUI". (Also, if you choose not to install the Graphical User Interface, you will
not have to use a special command line option to start the Softkey Interface.)
Refer to the Software Installation Notice for software installation instructions.
After you are done installing the software, return here.
Chapter 19: Installation and Service
Installing Sun SPARCsystem Software
707