HP MC68040 User Manual page 444

Chapter 11: Emulator Commands
copy
The copy command copies selected information to your system printer or listing
file, or directs it to an UNIX process.
Depending on the information you choose to copy, default values may be options
selected for the previous execution of the display command. For example, if you
display memory locations 10h through 20h, then issue a copy memory to myfile
command, myfile will list only memory locations 10h through 20h.
, A comma used immediately after memory in the command line appends the
current copy memory command to the preceding display memory command. The
data specified in both commands is copied to the destination specified in the current
command. Data is formatted as specified in the current command. The comma is
also used as a delimiter between values when specifying multiple memory
addresses.
<CLASS> Specifies a particular class of the emulator registers. See the "registers" parameter
in this section for more information about processor registers.
< !CMD!> This represents a UNIX filter or pipe where you want to route the output of the
copy command. UNIX commands must be preceded by an exclamation point (!).
An exclamation point following the UNIX command continues Softkey Interface
command line execution after the UNIX command executes. Emulation is not
affected when using a UNIX command that is a shell intrinsic.
data This allows you to copy a list of memory contents formatted in various data types
(see display data).
display
This allows you to copy the display to a selected destination.
error_log
This allows you to copy the most recent errors that occurred.
event_log
This allows you to copy the most recent events that occurred.
!
An exclamation point specifies the delimiter for UNIX commands. An exclamation
point must precede all UNIX commands. A trailing exclamation point should be
used if you want to return to the command line and specify noheader. Otherwise,
the trailing exclamation point is optional. If an exclamation point is part of the
UNIX command, a backslash (\) must precede the exclamation point.
—EXPR—
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying a memory address or offset value. See the EXPR syntax
diagram.
414