Table of Contents
Advertisement
Chapter 5: Using the Emulation-Bus Analyzer
Displaying the Trace List
To disassemble the trace list
• Choose Trace→Display Options... and in the dialog box, select Data Format
Mnemonic. Then click the OK or Apply pushbutton.
• Use the mouse to place the cursor on a line in the trace list where you want
disassembly to begin. Then press the select mouse button, and click on
Disassemble From in the trace list popup menu.
• Using the command line, enter commands as follows:
•
display trace mnemonic
•
display trace disassemble_from_line_number <LINE #>
<LINE #> is a line number corresponding to a state in the trace list.
Disassembly of instruction data means that you will see instructions as they would
appear in an assembly language program listing. That is, instruction mnemonics
and operands are shown instead of hexadecimal instruction data.
The analyzer interface normally disassembles instruction data in the trace list.
However, if you specify absolute data display, that mode remains in effect until
you select the mnemonic option.
When you identify a particular trace list line where disassembly is to begin, be sure
to specify a line number that corresponds to an analyzer state with an opcode fetch.
The analyzer interface disassembles and displays the trace starting with the state
you specify.
212
To disassemble instruction data in the trace list, enter:
To control where trace list disassembly starts, enter:
Advertisement
Table of Contents
