HP MC68040 User Manual page 541

Chapter 12: Emulator Error Messages
Conflicting disassembler option: <option> (Error 1000)
Conflicting disassembler option: <option> (Error 1000)
Cause: This error occurs when you attempt to specify inverse assembly options that
are not allowed with each other.
Action: Do not use conflicting inverse assembly options in the same trace list
command.
Continuing with default foreground monitor (Error 144)
Cause: You have downloaded a custom foreground monitor which was linked at an
address other than the monitor address specified within the emulation configuration.
Action: Change the monitor address within the emulation configuration or link your
custom monitor at the address specified in the configuration.
Copy memory aborted; next destination: <address> (Error 752)
Cause: One of these messages is displayed if a break occurs during processing of
the copy memory, or modify memory commands. The break could result from any
of the break conditions or could have resulted from a <CTRL> c break.
Action: Retry the operation. If breaks are occurring continuously, you may wish to
disable some of the break conditions.
Copy target image not supported (Error 175)
Cause: The cim (copy image memory) command cannot be used in this emulator.
Normally, the cim command would be used to copy a target system memory range
to emulation memory so you could set breakpoints or patch code.
Action: To do this without the cim command, save the target system memory range
to an absolute file using the copy command. Then remap the target memory range
to emulation memory, and load the absolute file into emulation memory using the
load command. Refer to Chapter 4, "Using the Emulator", for information on
saving and loading absolute files.
511