Step 1: Start The Demo - HP MC68040 User Manual

Chapter 1: Getting Started

Step 1: Start the demo

Step 1: Start the demo
A demo program and its associated files are provided with the Graphical User
Interface.
1 Change to the demo directory.
•
$ cd /usr/hp64000/demo/debug_env/hp64783
Refer to the README file for more information on the demo program. Type:
$ more README
2 Check that "/usr/hp64000/bin" and "." are in your PATH environment variable. To
see the value of PATH, type:
$ echo $PATH
3 If the Graphical User Interface software is installed on the same computer or same
type of computer that you are using to run this "Getting Started" procedure, skip
this step and go directly to step 4 of this "Start the demo" procedure.
If the Graphical User Interface software is installed on a different type of computer
than the computer you are using, edit the "platformScheme" resource setting in the
"Xdefaults.emul" file. For example, if the Graphical User Interface will be run on
an HP 9000 computer and be displayed on a Sun SPARCsystem computer, change
the platform scheme to "SunOS". This can't be done in the demo directory
specified above because the Xdefaults.emul file is write-protected. You will need
to move it to a new directory and then change its permissions. The best way to do
this is to enter the command:
$ Startemul <logical_emul_name>
In the above command, <logical_emul_name> is the logical name of your
emulator, given in the HP 64700 emulator device table file
(/usr/hp64000/etc/64700tab.net).
12
Type: