Chapter 3: Using the Emulator/Analyzer Interface
Starting the Emulator/Analyzer Interface
To execute a command file at interface startup
• Enter the emul700 -c <cmd_file> <emul_name> command.
Starting a command file (-c <cmd_file>) at emulator startup allows you to
automate some of the setup and configuration of the emulator. For example, you
may have a command file that loads a particular configuration file, a program file,
and then sets up trace display formats and specifications.
If the HP64KPATH variable is set, the interface will use the search paths specified
in this variable to locate a command file passed to it with the emul700 command.
Refer to the "Creating and Using Command Files" section later in this chapter for
information on creating command files.
Examples
To start the emulator/analyzer interface and run the "startup" command file, enter:
$ emul700 -c startup em68040
where "m68040" is the logical name for the HP 64783 MC68040 emulator.
55