HP MC68040 User Manual page 477

Any file specified by <FILE> cannot be named "configuration", "emul_mem",
"user_mem", "symbols", "trace", or "trace_spec" because these are reserved words,
and are not recognized by the emulation system as ordinary file names.
The absolute file is loaded into emulation memory by default.
configuration This option specifies that a previously created emulation configuration file will be
loaded into the emulator. You can follow this option with a file name. Otherwise
the previously loaded configuration will be reloaded.
demmuer
This option causes the emulator to read the MMU registers and MMU tables and
load the deMMUer with appropriate information to reverse-translate the physical
addresses it receives from the emulation bus so it can deliver corresponding logical
addresses to the analyzer.
emul_mem Load the file into emulation memory hardware.
FCODE
The function code used to define the address space being referenced. See the syntax
diagram for FCODE to see a list of the function codes available and for an
explanation of those codes.
<FILE>
This represents the absolute file to be loaded into either target system memory,
emulation memory (.X files are assumed), or the trace memory (.TR files are
assumed).
noabort
This option allows you to load a file even if part of the file is located at memory
mapped as "guarded" or "target ROM" (trom).
nosymbols This option causes the file specified to be loaded without symbols.
offset_by
This option allows you to offset the listed address values from the actual addresses.
The offset value you specify will be subtracted from the actual addresses.
symbols
This option causes the file specified to be loaded with symbols.
trace
This option allows you to load a previously generated trace file.
trace_spec
This option allows you to load a previously generated trace specification.
The current trace specification will be modified, but a new trace will not be started.
To start a trace with the newly loaded trace specification, enter trace again or
specify trace again (not trace). If you specify trace, a new trace will begin with
the default trace specification, not the one you loaded.
Chapter 11: Emulator Commands
load
447