Table of Contents
Advertisement
Chapter 19: Installation and Service
Verifying the Installation
A typical entry for a 68040 emulator connected to an RS-422 port would appear as
follows:
#-------------------------------------------------------------------------------
#
|
# Channel| Logical
#
Type
|
Name
#
|
#-------------------------------------------------------------------------------
serial:
em68040
Step 2. Start the interface with the emul700
command
The emul700 software is part of the HP 64700 Operating Environment software
you installed during the update process.
1 Apply power to the emulator you wish to access after making sure the emulator is
connected to the LAN or to your host system.
On the HP 64700 Series Emulator, the power switch is located on the front panel
near the bottom edge. Push the switch in to turn power on to the emulator.
2 Wait a few seconds to allow the emulator to complete its startup initialization.
3 Choose a terminal window from which to start the Graphical User Interface.
714
|
|
|
| Processor | Host |
|
Type
| Name |
|
|
|
m68040
myhost /dev/emcom23 OFF
|Xpar|Parity|Flow|Stop|Char
Physical
|Mode|
Device
|
|
|OFF | NONE |RTS | 2
NONE
|
|Bits|Size
|XON |
|
| 8
RTS
2
8
Advertisement
Table of Contents
