HP MC68040 User Manual page 126

Chapter 3: Using the Emulator/Analyzer Interface
Creating and Executing Command Files
PARMS &cfgname &binfile
load configuration &cfgname
load &binfile
The following command, entered on the command line, calls the command file
"loadany" and passes the actual parameters needed by the command file:
loadany democfg demo
You could start the command file "loadany" without parameters and allow the
interface to prompt you for the actual parameters. Issue the command:
loadany
and then respond to the parameter prompts. A prompt for the "cfgname" parameter
for this command file will look like the following:
STATUS: M68040--Running in monitor------------....
Define command file parameter [&cfgname]
You might also start the command file, supply just the first parameter, and have the
interface prompt you for the second parameter. Issue the command:
loadany democfg
to cause the interface to prompt you for the second parameter (&binfile).
96