HP MC68040 User Manual page 701

Antistatic precautions
Printed-circuit boards contain electrical components that are easily damaged by
small amounts of static electricity. To avoid damage to the emulator boards, follow
these guidelines:
•
•
•
Caution If you already have a modular HP 64700 Series Card Cage and want to remove the
existing emulator and insert an HP 64783A/B emulator in its place, the HP 64700
Series generic firmware and analyzer firmware may NOT be compatible, and the
software will indicate incompatibility. In this event, you must purchase a Flash
EPROM board to update the firmware. Instructions for installing this board and
programming it from a PC or HP 9000 are provided in the HP 64700 Card Cage
Installation/Service manual. Instructions for installing and updating emulator
firmware are covered in Chapter 20, "Installing/Updating Emulator Firmware".
Note
If you already have a modular HP 64700 Series Card Cage and want to remove the
1K analyzer and install the deep analyzer in its place, the analyzer firmware will be
updated by your installation because the analyzer firmware is contained on the
analyzer card.
Checking Hardware Installation
After hardware installation, run a performance test to verify that the emulator is
working properly. The performance verification procedure is described under
"Verifying the Installation" later in this chapter.
Service Information
Use this chapter when removing and installing hardware, running performance
verification, and ordering parts. See the HP 64700 Series Installation/Service
Guide for information on system configurations, installing product software,
software updates, and ordering parts for the card cage. Turn off power to the card
cage before removing or installing hardware.
If possible, work at a static-free workstation.
Handle the boards only by the edges; do not touch components or traces.
Use a grounding wrist strap that is connected to the HP 64700's chassis.
Chapter 19: Installation and Service
Installing Hardware
671