Table of Contents
Advertisement
Chapter 11: Emulator Commands
set
With the set command, you can adjust the display format results for various
measurements, making them easier to read and interpret.
Formatting of source lines, symbol display selection and width, and update after
measurement can be modified to your needs.
The display command uses the set command specifications to format measurement
results for the display window.
Another option to the set command, <ENV_VAR> = <VALUE>, allows you to
set and export system variables.
The default display format parameters are the same as those set by the commands:
set update
set source off symbols off
You can return the display format to this state by simply using the command:
set default
default
This option restores all the set options to their default settings.
demmuer
on
off
<ENV_VAR>
Specifies the name of an environment variable to be set within the HP 64000-UX
environment or the system environment.
=
The equals sign is used to equate the <ENV_VAR> parameter to a particular value
represented by <VALUE>.
472
This option turns on the deMMUer. Addresses on the
emulation bus will be reverse-translated (physical to logical)
before being supplied to the analyzer. Reverse translations will
be made according to the setup that was present in the MMU at
the time you entered your last load demmuer command.
This option turns off the deMMUer. Addresses on the
emulation bus will be supplied directly to the analyzer without
translation.
Advertisement
Table of Contents
