Table of Contents
Advertisement
Chapter 3: Using the Emulator/Analyzer Interface
Starting the Emulator/Analyzer Interface
If you are running a window system on your host computer (for example, the X
Window System), you can run the interface in up to 10 windows. This capability
provides you with several views into the emulation system. For example, you can
display memory in one window, registers in another, an analyzer trace in a third,
data in a fourth, and results of software performance measurements in the fifth (if a
software performance analyzer is installed as part of your system).
Examples
To start the emulator/analyzer interface for the MC68040 emulator, enter:
$ emul700 em68040
If you're currently running the X Window System, the Graphical User Interface
starts; otherwise, the Softkey Interface starts.
The status message shows that the default configuration file has been loaded. If the
command is not successful, you will be given an error message and returned to the
UNIX prompt. Error messages are described in Chapter 12, "Emulator Error
Messages".
To start the softkey user interface for the emulator/analyzer when the X Window
System is running, enter:
$ emul700 -u skemul em68040
To start the interface using the default
configuration
• Enter the emul700 -d <emul_name> command.
In the emul700 -d <emul_name> command, the -d option says to use the default
configuration. The -d option is ignored if the interface is already running in
another window or on another terminal.
54
Advertisement
Table of Contents
