Table of Contents
Advertisement
Examples
To disassemble instruction data in the trace list starting at line 40:
Place the cursor on line 40, press the select mouse button, and click on
Disassemble From in the popup menu.
Or, using the command line, enter:
display trace disassemble_from_line_number 40
To specify trace disassembly options
• Selection of disassembly options is not supported in pulldowns of the Graphical
User Interface. By default, the Graphical User Interface selects high_word and
all_cycles. Use the command-line if you need to specify trace disassembly using
other options.
• Using the command line, enter commands as follows:
•
display trace disassemble_from_line_number <LINE#>
instructions_only
•
display trace disassemble_from_line_number <LINE#>
all_cycles
•
display trace disassemble_from_line_number <LINE#>
high_word
•
display trace disassemble_from_line_number <LINE#>
low_word
To show only instruction cycles in the trace list, enter:
To show all bus cycles in the trace list, enter:
To start instruction disassembly from the upper word of the bus, enter:
To start instruction disassembly from the lower word of the bus, enter:
Chapter 5: Using the Emulation-Bus Analyzer
Displaying the Trace List
213
Advertisement
Table of Contents
