If You Can't Display The Program - HP MC68040 User Manual

Chapter 2: Solving Quick Start Problems

If you can't display the program

If you can't display the program
Verify that the program loaded correctly.
Check to see that the status of the emulator is reset or is running in monitor. See
the STATUS line on the display. If the emulator is halted, it can't use the monitor
to display program memory. In this case, reset the emulator and try to display the
program memory again.
Check the event log by choosing Display→Event Log, or by using the display
event_log command on the command line. If the event log shows that the program
loaded, try reloading the program again.
If you are displaying memory with symbols on, ensure that the symbol data base
has been loaded with the program. If this is the cause of the problem, you will be
able to obtain the memory display by referring to the address using its hexadecimal
value instead of its symbolic value. For example, to obtain a display of the
program in memory at symbolic address demo:main:
Move the mouse pointer to the entry buffer and type in "main"; and then select
Display→Memory→Mnemonic ().
or use the command line to enter:
display memory main mnemonic
44