Table of Contents
Advertisement
Chapter 6: Making Coordinated Measurements
Making Example Measurements
To break to the monitor on an analyzer trigger
signal
1 Enter the emulation configuration.
2 Set the emulator to receive trig1.
3 Set the emulation-bus analyzer to drive trig1.
4 Specify the trigger conditions for the trace.
5 Start the trace.
6 Start the program run.
The trigger signals and the analyzer trigger capabilities allow you to specify
breakpoints. You can use the trigger specification to specify complex sequences of
address, data and status, then break the program to the monitor when the sequence
is found. This is useful when you want to examine memory locations and registers
after the trigger condition occurs, but before further program execution.
You can use a similar process to break to monitor when a BNC trigger or CMB
trigger is received.
280
Advertisement
Table of Contents
