HP MC68040 User Manual page 577

Chapter 12: Emulator Error Messages
Unable to load new memory map; old map reloaded (Error 725)
Unable to load new memory map; old map reloaded (Error 725)
Cause: There is not enough emulation memory left for this request.
Action: Reduce the amount of emulation memory requested.
Unable to modify register: <register>=<value> (Error 632)
Cause: The emulator was unable to modify the register you requested.
Action: To resolve this, you must look at the other status messages displayed. It is
likely that the emulator was unable to break to the monitor to perform the register
modification.
Unable to read registers in class: <name> (Error 631)
Cause: The emulator was unable to read the registers you requested.
Action: To resolve this, you must look at the other status messages displayed. Most
likely, the emulator was unable to break to the monitor to perform the register read.
Unable to redefine label; used by emulation analyzer: <label> (Error 1108)
Cause: This error occurs when you attempt to redefine an emulation trace label that
is currently used as a qualifier in the emulation trace specification.
Action: Display the emulation trace sequencer specification in the easy
configuration, display the emulation trace patterns in the complex configuration, or
display the emulation trace format to see where the label is used. You must change
the pattern or format specification to remove the label before you can redefine it.
Unable to reload old memory map; hardware state unknown (Error 726)
Cause: Error occurred while trying to modify the emulation memory map.
Action: Usually there are other error messages present. Refer to their descriptions
to more fully understand the cause and action to take for this error.
547