Table of Contents
Advertisement
Using the Internal Analyzer
Introduction
Modifying the
Trace
Specification
Note
This chapter describes how to use the emulation analyzer from within
the PC Interface. The steps performed when using the analyzer are:
Modifying the trace specification (or using the default).
Starting the trace.
Displaying the trace.
These steps are described in the main sections of this chapter.
The PC Interface's "Analysis Trace Modify" command provides one
screen (with one subscreen) from which you make a complete trace
specifications. This section describes the options available on those
screens. To access the trace specification screen, select:
Analysis, Trace, Modify
If your emulator contains an external analyzer (which can operate as an
independent analyzer), you will have to include another option,
"Internal", to specify which analyzer the command is for.
The trace specification screen (see figure 2-1) shows the sequence
levels that are being used, the qualifiers associated with those levels,
2
Using the Analyzer 2-1
Advertisement
Table of Contents
