HP MC68040 User Manual page 646

Chapter 18: Connecting the Emulator to a Target System
Plugging The Emulator Into A Target System
Obtaining the terminal interface
The troubleshooting procedures in this chapter depend heavily on interpretation of
command-line prompts that are only seen at the low level terminal interface of this
emulator. Therefore, the commands you are told to enter are shown in the
terminal-interface form, and the displays you are told to look for are shown in this
chapter as they appear in the terminal interface.
To perform the procedures in this chapter, exit out of your emulator/analyzer and
invoke it through its terminal interface. Type the following command:
$telnet <hostname>
Where <hostname> is the name of the emulator. You could use the Internet
Protocol (IP) address (or internet address) in place of the emulator name, if desired.
For example:
$telnet 15.35.226.210
You should see messages similar to:
Trying...
Connected to 15.35.226.210
Escape character is '^]'
After you connect to the emulator, you should see a prompt similar to:
R>
This command-line prompt indicates the emulator is in the reset state.
Make sure you begin the emulation session with the emulator in its default state.
Initialize the emulator by entering the init command:
R>init
$ Limited initialization completed
616