Standards And Directives Complied With; Security Instructions; Pin Guidelines; Password Guidelines - Siemens FS720 Configuration
Fire detection system
Hide thumbs
Also See for FS720:
- Mounting & installation (248 pages) ,
- Commissioning, maintenance, troubleshooting (178 pages) ,
- Quick reference for components / pin assignment (130 pages)
Table of Contents
Advertisement
2.3 Standards and directives complied with
2.4 IT security instructions
2.4.1 PIN guidelines
2.4.2 Password guidelines
Building Technologies
Fire Safety
Modules and spare parts
●
Components and spare parts must comply with the technical specifications
defined by Siemens. Only use products specified or recommended by
Siemens.
●
Only use fuses with the specified fuse characteristics.
●
Wrong battery types and improper battery changing lead to a risk of explosion.
Only use the same battery type or an equivalent battery type recommended by
Siemens.
●
Batteries must be disposed of in an environmentally friendly manner. Observe
national guidelines and regulations.
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
●
Personal injuries or damage to property caused by improper use and incorrect
application
●
Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
●
Personal injury or damage to property caused by poor maintenance or lack of
maintenance
A list of the standards and directives complied with is available from your Siemens
contact.
You can log into the system and enable an 'Access level' with a Personal
Identification Number (PIN).
●
In general, preset PINs need to be changed during or immediately after
installation.
●
According to the Siemens IT security requirements, every PIN must contain 8
figures.
●
We do not recommend that service technicians create a PIN or change the
number of figures required for a PIN to a smaller number. This must be
documented.
●
In general, preset passwords need to be changed during or immediately after
installation.
●
A password should be made up of uppercase and lowercase letters, special
characters, and numbers. At least two of these character types need to be
used.
You will find more information on the password guidelines in document
A6V101039439; see chapter 'Applicable documents'.
Standards and directives complied with
Safety
2
23 | 412
A6V10210424_j_en_--
2018-08-29
Advertisement
Table of Contents
