Standard Keys - Siemens FS720 Configuration

'Operation' task card
13
Person Machine Interface (PMI)

13.2.3 Standard keys

264 | 412
Building Technologies
Fire Safety
Figure 88: 'Standard keys' element in the tree view
Each standard key can be assigned a function or a toggle function. With that you
can quickly carry out often used actions and commands.
You can configure the following types of functions:
● 'Dialog': The key is assigned to a specific view on the display of the ↑ Person
Machine Interface. Pressing on the key shows the view on the display e.g.
'Dialog 'Config viewer, Topology'' > 'Detection tree'.
● 'Action': The key is assigned to a pre-defined action. Pressing on the key
executes the action e.g. 'All sounders OFF'.
● Commands:
– Command for a specific element: The key is assigned to a command and
an element within the ↑ 'Site'. Pressing on the key executes the command
for this element, e.g., 'Detector test' for a particular 'Manual zone'.
– Command for the ↑ 'Zone' element category: The key is assigned to a
command and the 'Zone' element category. Pressing on the key shows the
window for entering the address for the 'Zone'. After entering the address,
the command for the corresponding element is executed.
When you configure a standard key, you must change the inscription on the
standard key on the Person Machine Interface, if required. You will find editable
inscription strips for the Person Machine Interface in the 'Inscription strips'
document. See chapter 'Applicable documents'.
You will find information on configuring standard keys in chapter 'Configuring
standard keys and favorites [➙ 267]'.
See also
2 Applicable documents [➙ 13]
A6V10210424_j_en_--
2018-08-29