Setting Up A Maximum Transmission Unit (Mtu) - Siemens FS720 Configuration
Fire detection system
Hide thumbs
Also See for FS720:
- Mounting & installation (248 pages) ,
- Commissioning, maintenance, troubleshooting (178 pages) ,
- Quick reference for components / pin assignment (130 pages)
Table of Contents
Advertisement
'Network' task card
14
Setting up a Maximum Transmission Unit (MTU)
14.4 Setting up a Maximum Transmission Unit (MTU)
328 | 412
Building Technologies
Fire Safety
●
For Cerberus-Remote
–
'Cerberus-Remote' > 'Connect'
The 'Connect' window is opened when a command is performed.
The default setting for the MTU size is 1500 bytes. If a FW update fails, you can
set lower values and apply them optionally for the 'Connection to IP address'.
The defined MTU size must be applied for remote access via cRSP.
Set the MTU as shown below:
Figure 148: Maximum Transmission Unit (MTU)
This setting can be selected optionally for a 'Connection to IP address'.
Figure 149: Maximum Transmission Unit (MTU) 02
A6V10210424_j_en_--
2018-08-29
Advertisement
Table of Contents
