Siemens FS720 Configuration page 355

Main features and typical
application
Building Technologies
Fire Safety
Typical event category
' ----Other extinguishing fault'
' --Earth fault'
' --Control test mode'
'System information'
Table 22: Properties of the template
Text that is shown on the display of the Person Machine Interface when the event
1
occurs.
Creating and configuring the 'Extinguishing sector control'
The sequence only contains the necessary configuration steps. You will find
information about the elements that can be assigned or created, as well as the
parameters, in separate sections further down in this chapter.
w An 'Extinguishing control group' element is created in the 'Control tree'. You will
find information on creating an 'Extinguishing control group' element in chapter
'Configuring an extinguishing control group [➙ 353]'.
1. Create an 'Extinguishing sector control' element under the 'Extinguishing
control group' element.
a The template creates an 'Extinguishing sector control' element.
a The template automatically creates two zone elements for 'Causes' and
'Effects' under the 'Extinguishing sector control' element. 'Causes' functions
and 'Effects' functions which have already been pre-configured can be
found within the zones.
2. Enter the required customer text in the 'Overview' tab.
3. Configure the 'Extinguishing sector control' element in the 'Overview' tab.
Extinguishing
Configuring flooding zone control
Event text
1
'PressureSw.timeout'
'Module reset req.'
'Input / output'
'Output fuse fault'
'X-bus fault'
'Configurat. fault'
'Fault aux.function'
'Earth fault ($(POLARITY))'
'Control test mode'
'Module config.runs'
A6V10210424_j_en_--
16
355 | 412
2018-08-29